|
olar Controller
|
|
|
|
Solar
controller manage solar thermal systems and ensure the optimum
solar yields. |
|
As soon as the temperature of the
collector exceeds the storage tank temperature, the controller
activates the circulation pump and the heat medium liquid
transports the heat, taken up at the collector, into the hot
water storage tank.
Conventional heating systems ensure a required after-heating
within the storage. Because of the easy integration into
building techniques and an average life expectation of more than
25 years, solar systems are an ideal complement to modern
heating technology.
|
|
 |
|
CIB
differential
temperature controllers are used in solar, heating and heat
pump systems to initiate switching processes depending on
thermal, hydraulic and environmental conditions.
In general,
the controller monitors the determined temperature
differences of the sensors and compares them to the given
set temperature differences. the controller is switched on
if the adjusted temperature difference is exceeded. The
system is controlled by one or more relays. Pumps or
electric valves may be connected to these relays.
The
controller also support remote monitor.
|
 |
|
|
|
|
 |
|
CA0/CA1
controller:
Project Smart Master
-temperature
differential recirculation
control:220v/5A
- pipe
recirculation control:220v/10A(Tailor)
|
|
|
|
|
|
 |
|
-
input:
4-5 data respectively collecting;
3 temperature collecting(4 temperature input
for CA3)
-
output:
4-5 outputs respectively control;
electromagnetic valve for continuous temperature
water supply（220v/5A or 12v/200mA);
water replenishing electromagnetic pump（220v/5A
or 12v/200mA);
differential temperature/frost protection
recirculation pump(220v/5A) ;
auxiliary heater(220v/10A);
pipe recirculation pump(220v/10A)(special for
CA3)
-
LED display
|
|
|
|
|
|
|
|
-installation: mounted or earthed
-input power:210v-250v
-input:8/16/24/32 and even more input
-output:8/16/24/32 and even more output
-temperature sensor model:mf53
-5.6 inch TFT touch display
-RS-485 remote monitor connect (optional)
|
| |
|
|
|
 |
|
KTD-pro
controller
-
input: 3 temperature respectively data
collecting:
2 temperature sensor;1 water volume sensor
-
output:3 output control:
auxiliary heating(220v/10A);
water replenishing electromagnetic pump
(12v/200mA);
heater band(220v/10A)
|
| |
|
|
|
|
|
transducer
container
-Fuji or senlan
transducer control;
-automatic
frequency conversion;
-one
transducer controls several pumps,automaticlly freely
change;
-operation
light display, condition monitoring
|
|
|
 controller |
|
|
| |
|
|
|
|
|
|
|
Back |
|
|
